Skip to content

Body Fat Calculator: US Navy Method

This body fat calculator (Navy method) estimates your body fat percentage, fat mass and lean mass from a few tape-measure readings.

Units
Sex
cm

kg

cm

Just below the larynx (Adam's apple), tape sloping slightly down to the front.

cm

Around the navel, level with the floor.

Body fat (US Navy method)

16.4%Fitness (ACE category)
Fat mass
13.1 kg
Lean mass
66.9 kg
Category
Fitness
Fat mass (16.4%)13.1 kgLean mass (83.6%)66.9 kg

How to use the Body Fat Calculator

  1. Choose Metric (cm, kg) or Imperial (in, lb) at the top, then pick your sex.
  2. Enter your height and weight.
  3. Measure your neck and waist (and hips, for women) with a flexible tape, following the hints under each field.
  4. Read your body fat percentage, fat and lean mass, and the ACE category it falls in.

Formula

Men: %BF = 495 ÷ (1.0324 − 0.19077 log₁₀(W − N) + 0.15456 log₁₀(H)) − 450

Where:

%BF
Body fat as a percentage of body weight
W
Waist circumference in cm: at the navel for men, at the narrowest point for women
N
Neck circumference in cm, just below the larynx
H
Height in cm
P
Hip circumference in cm at the widest point (women only)

Women: %BF = 495 ÷ (1.29579 − 0.35004 log₁₀(W + P − N) + 0.22100 log₁₀(H)) − 450. From Hodgdon and Beckett (Naval Health Research Center, 1984), with the Siri equation converting body density to percent fat. Inches are converted to cm (1 in = 2.54 cm) so both unit systems give the same answer.

Worked example

A man is 178 cm tall and weighs 80 kg. His neck measures 38 cm and his waist 85 cm. What is his body fat?

  1. Waist minus neck: 85 − 38 = 47 cm, and log₁₀(47) ≈ 1.67210. Height: log₁₀(178) ≈ 2.25042.
  2. Body density ≈ 1.0324 − 0.19077 × 1.67210 + 0.15456 × 2.25042 = 1.0324 − 0.31899 + 0.34782 ≈ 1.06124.
  3. Body fat = 495 ÷ 1.06124 − 450 ≈ 466.44 − 450 ≈ 16.4%.
  4. Fat mass = 80 × 0.1644 ≈ 13.1 kg; lean mass = 80 − 13.1 ≈ 66.9 kg.
  5. On the ACE chart for men, 14–17% is the fitness range.

He has about 16.4% body fat (fitness range): 13.1 kg of fat and 66.9 kg of lean mass.

How the Navy method estimates body fat

In 1984, James Hodgdon and Marcie Beckett at the Naval Health Research Center in San Diego measured hundreds of Navy men and women both with a tape and by underwater weighing, then found the combination of circumferences that best predicted body density. For men, waist minus neck carries most of the information; for women, waist plus hips minus neck. The Siri equation (1961) then turns density into a fat percentage: %BF = 495 ÷ density − 450.

This page uses the metric form of the equations. Inches are converted to centimeters exactly first, so both unit systems give the same answer.

How to measure neck, waist and hips

  1. Use a flexible, non-stretch tape, level and snug against the skin without compressing it.
  2. Measure in the morning, before eating or exercising, standing relaxed with your feet together.
  3. Neck: just below the larynx (Adam's apple), with the tape sloping slightly down toward the front. Keep your head level.
  4. Waist: men measure horizontally at the navel; women at the narrowest point, usually just above the navel. Breathe out normally and do not pull in your stomach.
  5. Hips (women only): around the widest part of the buttocks; a side-on look in a mirror helps.
  6. Measure each site three times and use the average.

The most common errors are sucking in the stomach, measuring the waist at the belt line, and pulling the tape tight around the neck, which makes the neck smaller and the result higher.

What is a healthy body fat percentage?

The result is labeled with the American Council on Exercise (ACE) chart:

CategoryWomenMen
Essential fat10 to 13%2 to 5%
Athletes14 to 20%6 to 13%
Fitness21 to 24%14 to 17%
Average25 to 31%18 to 24%
Obese32% and over25% and over

Essential fat is the minimum needed for normal body function, in nerves, bone marrow and cell membranes. Women's is higher because it also supports hormones and reproduction. A result below the essential range usually means a measurement error; if your measurements are right, discuss it with a doctor.

Fat mass and lean body mass

Fat mass is your weight multiplied by the body fat percentage; lean mass is everything else: muscle, bone, organs and water. Both are shown under the result, in kilograms or pounds.

Take a woman who is 5 ft 5 in (65 in) tall and weighs 140 lb, with a 13 in neck, 30 in waist and 40 in hips.

  1. Waist + hips − neck = 57 in = 144.78 cm; height = 165.1 cm.
  2. Body density ≈ 1.29579 − 0.35004 × log₁₀(144.78) + 0.22100 × log₁₀(165.1) ≈ 1.02958.
  3. Body fat = 495 ÷ 1.02958 − 450 ≈ 30.8%, in the average range for women.
  4. Fat mass ≈ 43.1 lb; lean mass ≈ 96.9 lb.

If her waist shrinks by 1 inch while everything else stays the same, the estimate drops by about 1.3 points to around 29.5%, even if the scale hardly moves. Lean mass is also the input the Katch-McArdle equation uses on the BMR page.

How accurate is the Navy method?

It is an estimate. Studies typically find it lands within about 3 to 4 percentage points of laboratory methods such as DEXA or underwater weighing for most adults. The equations were built from adult military personnel, mostly young and fit, so accuracy is lower for very lean, very muscular or very heavy people, older adults, and anyone with unusual fat distribution. Small tape errors matter too: for the 178 cm man in the example above, 1 cm more on the waist adds about 0.8 of a point.

A smart scale, calipers, DEXA and this formula will each give a different number. Pick one method and track the trend with it.

Navy, Army and official standards

This page implements the Navy circumference equations only. In 2023 the US Army moved to its own waist-only tape test with different equations, so results here will not match it. Military pass and fail limits are set by each service and revised from time to time; check the current official instruction rather than any figure quoted online.

Assumptions and sources

Equations from Hodgdon JA and Beckett MB, Naval Health Research Center Reports 84-11 and 84-29 (1984), with Siri WE (1961) for the density conversion. Categories from the ACE body fat chart, applied to the result rounded to one decimal place. Imperial units use 1 in = 2.54 cm and 1 lb = 0.45359237 kg. The method is not designed for children or during pregnancy.

This is general information, not a medical assessment. For a clinical measurement, or if you are concerned about your body composition, speak to a doctor or qualified health professional.

Frequently asked questions

How accurate is the US Navy body fat method?

For most adults it lands within about 3 to 4 percentage points of a laboratory measurement such as DEXA or underwater weighing. It is less accurate for very lean, very muscular or very heavy people, and small tape errors matter: for an average man, 1 cm on the waist moves the result by about 0.8 of a point.

How do I measure body fat percentage at home?

With a flexible tape. Men measure the waist horizontally at the navel; women at the narrowest point between the ribs and hips. Measure the neck just below the larynx, with the tape sloping slightly down at the front. Women also measure the hips around the widest part of the buttocks. Stand relaxed, do not pull in your stomach, and enter the readings with your height.

What is a healthy body fat percentage for men?

The American Council on Exercise chart puts average body fat for men at 18 to 24%, with a fitness range of 14 to 17% and an athletes range of 6 to 13%. Essential fat, the minimum the body needs, is about 2 to 5%. From 25% upward the chart uses the obese label. These ranges are a guide, not a medical diagnosis.

What is a healthy body fat percentage for women?

On the American Council on Exercise chart, average for women is 25 to 31%, fitness is 21 to 24% and athletes are 14 to 20%. Essential fat is about 10 to 13%, higher than for men because women carry fat in the breasts, hips and thighs and around organs that supports hormone function and reproduction. The chart uses obese from 32%.

How do I calculate body fat percentage?

With the Navy method, first estimate body density from your waist, neck and height (plus hips for women) using logarithms, then convert with the Siri equation: 495 ÷ density − 450. A man who is 178 cm with a 38 cm neck and 85 cm waist has a density of about 1.06124, which gives roughly 16.4% body fat. The tool does the arithmetic for you.

Is body fat percentage better than BMI?

It tells you more about what your weight is made of. BMI only compares weight with height, so a muscular person and a person with more fat can share the same BMI. Body fat percentage separates fat from lean mass, though tape-measure estimates have their own error.

Last updated: